Sunday, September 25, 2011

DIY Exhaust Repair

Because of rigid my chassis is and how bad the roads can be near me...my exhaust system does not like it too much. I noticed an exhaust leak in my old Exoticspeed Race Pipe, but I did not know it was this bad...

 


In times like these, J B Weld is your best friend!


J B Weld is a cold weld product that can withstand ~500°F which should patch this leak just fine. 

First squeeze out some of the 'Steel' into a small cup or paper towel.


Next squeeze an equal amount of the 'Hardener'.


Mix up the 'Steel' and 'Hardener'


Apply!




I am letting the J B Weld set for about 2 days just to me sure that everything is good and bonded.

No comments:

Post a Comment